Work's LED panels are dying

[HIDLamp]

FYI one of the LED panels in the suspended ceiling at work is going EOL. 1/4 of it is out completely and when it is cold the remaing working bits shimmer at about 30Hz for about 20mins untill it's warmed up. Even then it's illumination hasained a rather wavy effect across it's surface

[Slyspark]

Good! Hopefully they'll all fail and then they'll really see they should have kept the fluorescents

[HIDLamp]

All the fluros are boxed in the loft. Problem is there's no tubes for them

[Danny]

Go to kendal electric center and get a tonne out of the lamp bin

[Slyspark]

Well, if all the LED panels die, buying a couple of boxes of tubes is a MUCH cheaper solution than buying a load more LED panels! They'll likely last longer too!

[Ash]

You can tell this to peeps over here that will buy panels after panels and still not FL

[Slyspark]

It's the same here, everyone's been brainwashed into LED LED LED and nothing else. Cos of course, every time you fit a fluorescent or discharge light, a polar bear dies.....