Page 1 of 1
Work's LED panels are dying
Posted: Wed Jan 17, 2018 10:31 pm
by HIDLamp
FYI one of the LED panels in the suspended ceiling at work is going EOL. 1/4 of it is out completely and when it is cold the remaing working bits shimmer at about 30Hz for about 20mins untill it's warmed up. Even then it's illumination hasained a rather wavy effect across it's surface
Re: Work's LED panels are dying
Posted: Wed Jan 17, 2018 10:33 pm
by Slyspark
Good! Hopefully they'll all fail and then they'll really see they should have kept the fluorescents
Re: Work's LED panels are dying
Posted: Thu Jan 18, 2018 7:04 pm
by HIDLamp
All the fluros are boxed in the loft. Problem is there's no tubes for them
Re: Work's LED panels are dying
Posted: Thu Jan 18, 2018 7:10 pm
by Danny
Go to kendal electric center and get a tonne out of the lamp bin
Re: Work's LED panels are dying
Posted: Thu Jan 18, 2018 8:13 pm
by Slyspark
Well, if all the LED panels die, buying a couple of boxes of tubes is a MUCH cheaper solution than buying a load more LED panels! They'll likely last longer too!
Re: Work's LED panels are dying
Posted: Mon Feb 05, 2018 11:20 pm
by Ash
You can tell this to peeps over here that will buy panels after panels and still not FL
Re: Work's LED panels are dying
Posted: Mon Feb 05, 2018 11:36 pm
by Slyspark
It's the same here, everyone's been brainwashed into LED LED LED and nothing else. Cos of course, every time you fit a fluorescent or discharge light, a polar bear dies.....