Sylvania 20w T12 530 IRS
Interesting MCF-A lamps with metallic earthing strip for better performance on rapid and instant start circuits but far more likely to get around the EU T12 ban!

Sylvania 20w T12 530 IRS

Interesting MCF-A lamps with metallic earthing strip for better performance on rapid and instant start circuits but far more likely to get around the EU T12 ban!

DPP00003276.JPG DPP00003305.JPG DPP00003306.JPG DPP00003326.JPG DPP00003331.JPG
File information
Filename:DPP00003306.JPG
Album name:FrontSideBus / Linear Fluorescent
Filesize:1987 KiB
Date added:13 Apr, 2016
Dimensions:1920 x 1280 pixels
Displayed:41 times
URL:http://80.229.24.59:9232/gallery/displayimage.php?pid=3595
Favourites:Add to Favourites

Comment 1 to 6 of 6
Page: 1

Danny   [13 Apr, 2016 at 07:46 PM]
Wow not seen sylvies with earth stripes!
FrontSideBus   [16 Apr, 2016 at 01:07 PM]
They certainly are very keen to start. They strike instantly with no starter switch installed! Even 4-22w starters sometimes fail to catch them.
Kev   [17 Apr, 2016 at 07:24 AM]
Let just pray we get out of Europe in June
FrontSideBus   [17 Apr, 2016 at 04:38 PM]
I highly doubt it will happen. Too many vested interests and the EU wont accept it, just like they did with the Irish!
fluorescent   [07 Jul, 2017 at 08:46 PM]
I love how lazily the starting strips have been applied, some straight over the etch! In fact the very top tube in this picture is now perfectly safe to dispose of in general waste lol
Lightbulbfun   [15 Apr, 2024 at 12:23 AM]
worth pointing out that these actually are TLM tubes rather then MCFA tubes, TLM tubes have 3.6V cathodes and the starter stripe is tied to one electrode by a high resistance, as *not* supposed to be grounded, in this fashion it works a lot like the starting probe does on a mercury vapour lamp Smile the resistor Sylvania use in these tubes is a bit weedy mind, not sure I would trust it with mains against it! (in terms of the physical size of the resistor, not its actual ohm rating) see here

MCFA tubes have 9V cathodes, and a starter stripe thats not connected to any electrode, and should be grounded, if you where to install an IRS/TLM type tube in an MCFA quickstart fitting, the 9V cathode heating would soon munch the 3.6V TLM tube!

Comment 1 to 6 of 6
Page: 1

Add your comment
Anonymous comments are not allowed here. Log in to post your comment