Atlas superslim restored - end closeup
This was rescued by a mate, who said it was one of two in use in a shed until it was pulled down. Both had been placed at the curb, and he got one with me in mind. He could only carry the one, so when he went back later in the day the second had sadly gone.
The internals was in a right state, but thankfully the ballast escaped rusting. Its another example that had fell to the can o' gloss paint, so it warranted a full strip back and respray.

Atlas superslim restored - end closeup

This was rescued by a mate, who said it was one of two in use in a shed until it was pulled down. Both had been placed at the curb, and he got one with me in mind. He could only carry the one, so when he went back later in the day the second had sadly gone.
The internals was in a right state, but thankfully the ballast escaped rusting. Its another example that had fell to the can o' gloss paint, so it warranted a full strip back and respray.

DSC05027.JPG DSC06629.JPG PICT0959.JPG DSC06601.JPG DSC03242.JPG
File information
Filename:PICT0959.JPG
Album name:Dave / Fluorescent fittings
Filesize:2630 KiB
Date added:14 Jan, 2016
Dimensions:2730 x 2048 pixels
Displayed:69 times
URL:http://80.229.24.59:9232/gallery/displayimage.php?pid=2806
Favourites:Add to Favourites

Comment 1 to 9 of 9
Page: 1

lampy   [14 Jan, 2016 at 08:02 PM]
what did you do for an green atlas sticker?
Dave   [14 Jan, 2016 at 08:57 PM]
I havent got one to use as a basis to replicate, else I'd have done just that. Need a better sticker for the Ekco one tbh.
Dave   [14 Jan, 2016 at 09:09 PM]
Btw I PM'd you.
XmasLightGuy   [16 Jan, 2016 at 04:38 PM]
Nice restore job. Looks like new Cool
BC5-80   [29 Jun, 2016 at 08:41 PM]
That's a beauty.
Slyspark   [30 Jun, 2016 at 11:44 PM]
Surprising how well these clean up! Just done one myself, hopefully the paint job will last longer than the rather thin factory version!
lampy   [14 Mar, 2018 at 06:30 PM]
yes these only got a waft of paint from the factory on bare steel i think which is why it just crazes up and falls off !
fluorescent   [14 Mar, 2018 at 09:44 PM]
I think BLI used to just run their freshly made, bare steel fixtures past the air vent at the Crompton factory paint booth Laughing
lampy   [14 Mar, 2018 at 10:30 PM]
atlantics had a good paint finish, think that was stove enamel, had a high gloss finish and lasted well

Comment 1 to 9 of 9
Page: 1

Add your comment
Anonymous comments are not allowed here. Log in to post your comment