Industria 2500 gear layout.

Anyone who knows me knows that I have an OCD for tidy wiring, and this has once again been shown to full effect in this conversion. The white clips on the gear tray allowed for up to four wires to pass though, as can be seen this has definitely been put to good use. These gear trays are of a type where a threaded metal nut is cold stamped into the gear tray, effectively welding it in place. I had planned to wire each tube individually, but since there was only two spaces for two ballasts, deemed this the better solution in the longrun. All starter link wires between tubes are of a different colour to allow one to identify the individual circuits with better accuracy.